West-control-solutions KS 800 CANopen Interface Manual Manual de usuario descargar pdf (Pagina 12)

KS 800 CAN-Interface

3.3 PDO transfer behaviour

3.3.1 Asynchronous send PDO

When a PDO is configured as an asynchronous PDO, a PDO is sent with status-information-

resp. Ypid- changes of a channel. The message order is: checking whether sending is necessary

starts with the first channel. If a change-of-state is detected (flag fSendEvent set), a PDO is

generated, sent and the flag is reset. After successful sending, the next channel is handled. If

the two send PDOs are configured as asynchronous PDOs, two channels are checked and sent

simultaneously.

Example:

Channel 1: fSendEvent = TRUE

→ send PDO for channel 1

Channel 2: fSendEvent = FALSE

Channel 3: fSendEvent = TRUE

→ send PDO for channel 3

Channel 4: fSendEvent = FALSE

Channel 5: fSendEvent = FALSE

Channel 6: fSendEvent = FALSE

Channel 7: fSendEvent = TRUE

→ send PDO for channel 7

Channel 8: fSendEvent = FALSE

Channel 1: fSendEvent = FALSE

An asynchronous PDO is always sent by KS800 with status bit change-of-state or changing of

Ypid. In default configuration, the message sent by KS800 is:

Message from KS800 (ASYNC-PDO):

8 data bytes

COB-ID LEN Channel Xeff Dev. st. Channel st. Ypid

0x180 +node 8 0x05 0xBC 0x02 0x00 0x00 0x42 0xF4 0x01

⇒ Xeff = 0x02BC = 700 = 70,0°C

⇒ Device Status = 0x00 = keine Fehler

⇒ Channel Status = 0x4200 = Coff = 1, Wint = 1

⇒ Ypid = 0x01F4 = 500 = 50%

12 9499 040 49511

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Sin comentarios

West-control-solutions KS 800 CANopen Interface Manual Manual de usuario Pagina 12